13 62 591 Removing and installing/replacing pressure sensor on left charge air cooler (S63)

Necessary preliminary tasks: 

• Read out DME control unit fault memory.
• Switch off ignition
• Remove left INTAKE FILTER HOUSING 

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 7AZ .

Pull pressure sensor (3) out of left charge air cooler.

Installation note: 

Replace sealing ring on pressure sensor.

Fig 1: Identifying Pressure Sensor, Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Delete fault memory.