13 62 560 Removing and installing/replacing left or right hot film air mass meter (N63O1)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Picture shows the left side, the procedure for the right side is identical.

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 6AZ .

Pull hot film air mass meter (3) out of upper section of intake silencer housing.

Installation note:

Replace gasket on hot film air mass meter.

Fig 1: Identifying Hot Film Air Mass Meter, Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.

Clear diagnostic fault entries from fault memory.