Overview of tightening torques
WARNING: This page is about a different variant/trim than selected.
| Use in Activity: 9 |
| Feed line to high pressure pump, cylinder head, retaining clip |
| M14, feed line to high pressure pump |
Initial torque |
10 Nm |
| Manually tighten feed line to high pressure pump, cylinder head and retaining tab or loosen beforehand. |
Final torque (retorque twice) |
30 Nm |
M6, feed line to cylinder head
Manually tighten feed line to high pressure pump, cylinder head and retaining tab or loosen beforehand. |
Final torque |
10 Nm |
M6, feed line to retaining clip
Manually tighten feed line to high pressure pump, cylinder head and retaining tab or loosen beforehand. |
Final torque |
10 Nm |
| Use in Activity: 10 |
| Clean air pipe to exhaust turbocharger |
| M6 |
10 Nm |
| Use in Activity: 11, 12 |
| Charge air line to charge air cooler |
| Replace clamp |
3, 5 Nm |
| Use in Activity: 11, 12 |
| Charge air line to exhaust turbocharger |
| Replace clamp |
3, 5 Nm |
| Use in Activity: 13 |
| Clamp to air duct |
| |
3 Nm |
| Use in Activity: 14 |
| Battery earth lead |
| M6 |
5 Nm |