72 11 092 Removing and installing/replacing rear left or right seat belt (roller)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary work:
- Remove BACKREST
NOTE:
Illustration shows removal of left side.
The right side is removed in the same way as the left side.
The right side is removed in the same way as the left side.
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of hardening)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Release screw (1).
Tightening torque 72 11 23AZ .
Installation note:
Replace microencapsulated screw.1
Remove reversing clip (2).
Installation note:
Align the seat belt guide lop parallel to the screw connection.
Release screw (1).
Tightening torque 72 11 20AZ .
Remove inertia reel unit (2).
Installation note:
Inertia reel unit (2) is coded against incorrect installation.
Release screw (2).
Tightening torque 72 11 21AZ .
Remove seat belt.
Installation note:
End fitting (1) is encoded against incorrect assembly with limit position (3).