17 11 200 Removing and installing/replacing engine oil cooler (S63)
WARNING: This page is about a different variant/trim than selected.
WARNING:
Risk of scalding!
Only perform this repair work after engine has cooled down.
Only perform this repair work after engine has cooled down.
IMPORTANT:
Wear safety goggles and protective gloves.
Necessary preliminary tasks:
- Remove front UNDERBODY PROTECTION .
IMPORTANT:
Adhere to conditions of absolute cleanliness when repairing the engine oil circuit.
When removing engine oil pipes and engine oil cooler, seal off all openings with suitable plugs.
To avoid engine damage, do not allow any dirt particles to get into the engine oil circuit.
When removing engine oil pipes and engine oil cooler, seal off all openings with suitable plugs.
To avoid engine damage, do not allow any dirt particles to get into the engine oil circuit.
Recycling:
Engine oil escapes when engine oil pipes are released. Catch and dispose of emerging engine oil.
Observe country-specific waste disposal regulations.
Release screws (1).
Tightening torque 17 22 4AZ .
Pull engine oil pipes off of engine oil cooler.
Catch and dispose of emerging oil.
Unfasten screws (2).
Tightening torque 17 22 5AZ .
Remove engine oil cooler (3).
NOTE:
After the repair work is completed, check the oil level. Top up engine oil if necessary.