17 11 150 Removing and installing/replacing additional water cooler (N55)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove FRONT SECTION OF WHEEL ARCH COVER on left.
WARNING:
Risk of scalding!
Only perform this repair work after engine has cooled down.
Only perform this repair work after engine has cooled down.
IMPORTANT:
Wear safety goggles and protective gloves.
Recycling:
Coolant emerges when coolant lines are detached. Catch and dispose of escaping coolant in a suitable container.
Observe country-specific waste disposal regulations.
Detach coolant lines (1).
Catch and dispose of escaping coolant.
Release screw (2).
Tightening torque 17 10 8AZ .
Removing auxiliary coolant cooler (3).
Installation note:
Check coolant hoses for damage.
NOTE:
After completion of repair work, check coolant level.
If necessary, ADD COOLANT .
Reassemble the vehicle.
If necessary, ADD COOLANT .
Reassemble the vehicle.