65 50 057 Removing and installing/replacing Central Information Display (CID)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

NOTE: Build version up to 07/2012 only.

Unclip the screw covers (1) from CID (2).

Release screws underneath.

Tightening torque 65 50 2AZ .

Installation note:

To tighten screws, use special tool 00 9 460 .

Fig 1: Identifying CID Screw Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (2).

Tightening torque 65 50 1AZ .

Installation note:

To tighten screws, use special tool 00 9 460 .

Unclip CID (1) in direction of arrow from rear cover.

Fig 2: Removing CID From Rear Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

CID must noticeably and audibly lock at the marked points on the rear cover (1).

Fig 3: Identifying Fastening Points For CID On Rear Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Replacement: