65 13 188 Removing and installing/replacing rear mid-range speaker (in storage shelf)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Lift speaker cover (1) out of storage shelf (2) using special tool 00 9 341 .

Fig 1: Lifting Speaker Cover Out Of Storage Shelf Using Special Tool 00 9 341

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining lugs (1) on speaker cover (2) must not be damaged.

Replace speaker cover (2) if damaged.

Make sure speaker cover (2) is fully engaged.

Fig 2: Identifying Speaker Cover Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws at marked points.

Remove mid-range speaker (1) upwards from storage shelf (2).

Disconnect associated plug connection and remove mid-range speaker (1).

Fig 3: Removing Mid-Range Speaker Upwards From Storage Shelf

Courtesy of BMW OF NORTH AMERICA, INC.