65 13 062 Removing and installing/replacing speaker (tweeter, in dashboard)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Unclip trim (1) with special tool 00 9 327 from latch mechanisms and remove upwards.

Fig 1: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining lugs and clamps at marked points must not be damaged.

Fig 2: Locating Clamps And Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 65 13 6AZ .

Installation note:

To tighten screws, use special tool 00 9 460 .

Remove the tweeter (2) from the dashboard.

Fig 3: Identifying Tweeter Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure resistor (1) is correctly seated in the corresponding bracket.

Fig 4: Identifying Resistor

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 65 13 5AZ .

Installation note:

To tighten screws, use special tool 00 9 460 .

Remove mid-range speaker (2) from dashboard (3).

Fig 5: Removing Mid-Range Speaker From Dashboard

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (3) from midrange speaker (1).

Remove tweeter (2).

Fig 6: Identifying Tweeter And Midrange Speaker Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.