65 13 060 Removing and installing/replacing speaker (midrange speaker, in instrument panel)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Unclip trim (1) from latch mechanisms using special tool 00 9 327 and remove upwards.

Fig 1: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Clamps and guides on marked points must not be damaged.

Fig 2: Locating Clamps And Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 65 13 5AZ .

Installation note:

To tighten screws, use special tool 00 9 460 .

Remove mid-range speaker (2) from dashboard (3).

Disconnect plug connection underneath.

Remove mid-range speaker (2).

Fig 3: Removing Mid-Range Speaker From Dashboard

Courtesy of BMW OF NORTH AMERICA, INC.