65 13 057 Removing and installing/replacing speaker system (High End sound system, in dashboard trim panel)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

00 9 340

Necessary preliminary work:

Remove COVER ON SPEAKER SYSTEM

NOTE: Picture for example purposes, F12 model shown.

Use special tool 00 9 340 to unclip cover (1) at marked points.

Fig 1: Removing Cover Using Special Tool 00 9 340

G09929622

Courtesy of BMW OF NORTH AMERICA, INC.

Clamps on cover (1) must not be damaged.

Replace clamps if necessary.

Fig 2: Locating Clamps On Cover

G09929623

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (2).

Remove cover (1).

Fig 3: Identifying Cover And Plug Connection

G09929624

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove speaker system (2) from dashboard.

Fig 4: Identifying Speaker System And Screws

G09929625

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and disconnect.

Remove speaker system (2).

Fig 5: Identifying Speaker System Plug Connection

G09929626

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Speaker system (1) must be adjusted.

Observe the following notes for this:

Insertion of speaker system (1) in dashboard
Placement of cover (2), this pre-centers of speaker system
Removal of cover (2) and screw connection from the two front screw points
Renewed placement of cover (2) and if necessary subsequent centering of speaker system
Removal of cover (2) and screw connection from the two rear screw points
Renewed placement of cover (2)
If joint speaker system (1) not OK, then manual fine tuning of joint

Fig 6: Identifying Speaker System And Cover
Courtesy of BMW OF NORTH AMERICA, INC.