65 24 020 Removing and installing/replacing wave trap

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Unlock plug connections (1) and disconnect.

Release screw (2).

Remove blocking circuit (3).

Fig 1: Identifying Blocking Circuit Plug Connections And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Fit wave trap (1) so that screw (2) engages thread (3) and locating pin (4) engages bore (5).

Fig 2: Identifying Wave Trap, Screw, Thread, Locating Pin, And Bore

Courtesy of BMW OF NORTH AMERICA, INC.