65 11 075 Removing and installing/replacing DVD changer

WARNING: This page is about a different variant/trim than selected.

Special tools required:

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

NOTE: Comply with notes on HANDLING OPTICAL FIBRES .

Necessary preliminary tasks:

Open glove box cover (3).

Unclip trims (1) with a suitable tool and release screws behind.

Using special tool 00 9 327 , press DVD changer (2) down slightly and then pull out forward out of glove box.

Pull DVD changer (2) out of guide.

Fig 1: Removing DVD Changer

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Remove DVD changer (2).

Installation note:

Insert DVD changer (2).

Pull down wiring harness (3) over opening (4).

Fig 2: Identifying DVD Changer Plug Connection And Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: