65 75 055 Removing and installing/replacing emergency power siren with tilt sensor

Necessary preliminary work: 

• Remove GUIDE FOR BUMPER AT REAR RIGHT

Secure guide for bumper (3) against falling out.

Unfasten plug connection (1) and disconnect.

Slacken nut (2).

Fig 1: Identifying Bumper Guide, Plug Connection And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock catch (1).

Remove emergency power siren (2) from guide for bumper (3).

Catch (1) must not be damaged.

Make sure emergency power siren (2) is correctly seated on guide for bumper (3).

Fig 2: Identifying Emergency Power Siren, Bumper Guide And Catch

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Carry out VEHICLE PROGRAMMING/ENCODING .