65 77 534 Removing and installing/replacing front right sensor (US version only)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screw (1) on auxiliary radiator holder (2).

Remove auxiliary radiator holder (2) and carefully place to one side.

Installation note:

Auxiliary radiator holder (2) must be correctly seated in the designated guides.

Fig 1: Identifying Auxiliary Radiator Holder And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on air duct (2).

Fig 2: Identifying Air Duct Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Fold air duct (4) to one side.

Release screws (3).

Tightening torque 65 77 2AZ .

Feed out sensor (1).

Unfasten plug connection (2) and disconnect.

Installation note:

Make sure sensor (1) is in correct installation position.

Sensor surface must point upwards.

Plug connection (2) must point in opposite direction to direction of travel.

Fig 3: Identifying Air Duct, Screws, Plug Connection, And Sensor

Courtesy of BMW OF NORTH AMERICA, INC.