12 14 650 Replacing suction pressure sensor on intake plenum (N55)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary work:

Unlock plug (1) and remove.

Release screws and pull suction pressure sensor (2) out of intake plenum.

Tightening torque 13 62 4AZ .

Fig 1: Identifying Pressure Sensor, Plug And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check sealing ring for damage. Replace sealing ring if damaged.

When installing, coat sealing ring with suitable lubricant.

Fig 2: Locating Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Reassemble the vehicle.
Check stored fault message.
Delete fault memory.