64 11 326 Replacing the button caps of the heating and air conditioning system control panel

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Tape area (1) around the button caps with adhesive tape.

Fig 1: Identifying Tape Area Around Button Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Press blower rocker switch (1) on one side and pry it off on the other side with special tool 00 9 340 .

Fig 2: Pressing Blower Rocker Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Pry off remaining button caps (1) with special tool 00 9 340 .

Fig 3: Removing Button Caps Using Special Tool 00 9 340

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in button caps (1) into operating unit.

Remove adhesive tape.

Fig 4: Clipping Button Caps Into Operating Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Check function of the air conditioning.