LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Heating And Air Conditioning - Repair - F13) >> Condenser And Dryer With Lines >> 64 53 521 Replace safety pressure switch (N52T, N54, N55, B47)

64 53 521 Replace safety pressure switch (N52T, N54, N55, B47)

WARNING: This page is about a different variant/trim than selected.
WARNING: Danger of injury!
Refrigerant circuit is under high pressure!
Avoid contact with refrigerant and refrigerant fluid.
Read and comply with safety instructions:
IMPORTANT: Risk of damage!
Restart engine only when A/C system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit.
If air conditioning system is opened for more than 24 hours: Replace desiccant insert for air conditioning  . See 64 53 517 REPLACING DESICCANT INSERT FOR AIR CONDITIONING SYSTEM  or 64 53 518 REPLACING DESICCANT INSERT FOR A/C SYSTEM (CAPACITOR REMOVED) .

Necessary preliminary tasks: 

Release screws (1) and (2).

Remove heat shield (3).

Fig 1: Identifying Heat Shield Screws
G08474064Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Release safety pressure switch (2).

Tightening torque 64 53 8AZ .

Fig 2: Identifying Safety Pressure Switch Plug Connection
G06886390Courtesy of BMW OF NORTH AMERICA, INC.

After installation: