52 14 002 Removing and installing front passenger seat (normal/electric)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
An airbag module and a pyrotechnical seat belt tensioner are installed in the front seat.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Installation note:
- Powerlok screws must be replaced and must not be reused
- Powerlok screws are mechanical screw locks with trilobular threads
Carefully raise tab (1) and pull cover toward the front.
Unlock retaining lug and pull cover to the back.
Move seat backwards.
Release and dispose of screws (1).
Move front seat forwards.
Release and dispose of screws (1).
- Unlock side cover in direction of arrow.
- Pull cover towards front.
Installation note:
Make sure cover is correctly latched.
Installation note:
Retaining lugs must not be damaged.
Replace cover, if necessary.
Unfasten plug connection (1) and disconnect.
Release wiring harness at clips (2 and 3).
IMPORTANT:
Cover door sill with protective covers (risk of damage).
Lift out front seat.
Installation note:
- Carpet must not get between seat rails and floor panel in area of attachment points (squeaking noises)
- Insert all screws loose to avoid twisting
- Tighten down all screws to specified torque
Tightening torque: 52 10 1AZ
WARNING:
When carrying out further work on the front seat, it is absolutely imperative to observe the SAFETY REGULATIONS
on handling airbag modules and pyrotechnical seat belt tensioners
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.