67 32 600 Replacing fans for seat surface on front seat

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Partially remove seat cover for driver's or front passenger seat. See REPLACING SEAT COVER FOR DRIVER'S SEAT or REPLACING SEAT COVER FOR PASSENGER FRONT SEAT .
If applicable, remove the Sensor mat (OC3-mat) or. SENSOR MAT (CIS MAT)

Unfasten plug connection.

Installation note:

Make sure fans have correct cable routing.

Fig 1: Identifying Correct Cable Routing

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For purposes of clarity, picture shows seat cushion and seat cover removed.

Raise separating net (1).

Pull faulty fans (2) out of seat cushion slightly and disconnect plug connections behind.

Fig 2: Identifying Fans And Dividing Net

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: