27 10 050 Replacing output flange for output to the front axle (ATC 35L)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not move vehicle with drive power once propeller shaft has been removed.
Replace output flange only together with a new radial shaft seal.
After completion of work, check GEARBOX OIL LEVEL .
Use only the APPROVED GEARBOX OIL .
Failure to comply with this requirement will result in serious damage to the transfer box!
Replace output flange only together with a new radial shaft seal.
After completion of work, check GEARBOX OIL LEVEL .
Use only the APPROVED GEARBOX OIL .
Failure to comply with this requirement will result in serious damage to the transfer box!
Operation is identical to REPLACING RADIAL SHAFT SEAL FOR FRONT AXLE OUTPUT .