24 14 004 Replacing shaft seal for selector shaft (GA8HP45Z)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation.
IMPORTANT:
After completion of repair work, check TRANSMISSION OIL LEVEL
.
Use only approved GEARBOX OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Use only approved GEARBOX OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
- Remove automatic transmission See 24 00 033 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA8HP45Z) (N20, N26) or 24 00 033 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA8HP45Z) (N47) .
- Remove MECHATRONICS .
Using a suitable tool, drive clamping sleeve (1) out of selector shaft.
Withdraw selector shaft (2) outwards.
NOTE:
Return spring is under tension.
Installation note:
Replace selector shaft (2).
Replace clamping sleeve (1).
Insert narrower end of clamping sleeve (1) into hole first. Using a suitable tool, drive in clamping sleeve until it is flush with the hole.
Screw in special tool 24 5 367 until it is firmly connected with radial shaft seal.
Screw special tool 24 5 362 onto special tool 24 5 367 and tighten down.
This pulls the shaft seal out of the transmission housing.
Oil sealing lip on shaft seal (1).
Drive radial shaft seal (1) fully home using special tool 24 5 366 and plastic hammer.