22 32 001 Replacing rubber mount for transmission mounting (ATC 35L) (N47)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 22 1 042/041
- 22 1 043
- 33 4 460
- 22 1 017
- 22 1 046
- 22 1 044
- 33 4 466
- 33 4 465
Necessary preliminary tasks:
- Remove exhaust system . See 18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM (N47 D16/20 K/U/O/T 1) or 18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM (N20, N26) .
- Remove CROSS MEMBER for transmission mounting.
Mount special tool 22 1 042/041 on transfer box.
Pull out rubber mount with thrust plate 22 1 043 by means of spindle 33 4 460 and nut 22 1 017.
Installation note:
Observe installation position of rubber mount.
Arrow on rubber mount must point to arrow on housing.
Coat housing bore and rubber mount with Circolight.
Insert special tool 22 1 046 with bolt into recesses of rubber mount.
Bolt special tool 22 1 044 to transfer box.
Insert special tool 22 1 046 with bolt into recesses of rubber mount.
Draw in rubber mount with special tools 33 4 466 and 33 4 465.
Installation note:
Auxiliary installation material - low-surface-tension water.
Do not coat rubber mount with grease.