LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 892 (Propeller Shaft - Repair - F31) >> Propeller Shaft, General >> 26 Additional work on four-wheel drive vehicles after driving with defective (non-engaging) drive

26 Additional work on four-wheel drive vehicles after driving with defective (non-engaging) drive

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If the vehicle has been moved under engine power with a non-engaging drive system (e.g. front propeller shaft defective and no longer engaging with the front differential or 1 output shaft no longer engaging with drive flange), it is imperative that the transfer box is calibrated after repairing the propeller shaft/output shaft(s).

After completing repairs, perform calibration using BMW diagnosis and information system and selecting Control unit function - Function check - Transfer box.

scientia non olet · About LEMON Manuals