12 61 280 Removing and installing/replacing oil pressure switch (N47 D16/20 K/U/O/T 1)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
When working on the oil, coolant or fuel circuit, you must protect the alternator against contamination.
Cover alternator with suitable materials.
Failure to comply with this procedure may result in an alternator malfunction.
Cover alternator with suitable materials.
Failure to comply with this procedure may result in an alternator malfunction.
Necessary preliminary tasks:
- Remove ACOUSTIC COVER
- Remove ELECTRONICS BOX .
NOTE:
The oil pressure switch is located beneath the high pressure pump.
IMPORTANT:
A small amount of engine oil emerges when oil pressure switch is removed.
Have a cleaning cloth ready.
Have a cleaning cloth ready.
Release connector and remove.
Release oil pressure switch.
Installation note:
Replace sealing ring.
Tightening torque 12 61 1AZ .
Reassemble the vehicle.
Check engine oil level.