52 14 040 Removing and installing/replacing outer cover on left or right front seat (normal/electric)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Move backrest to full rearward position.

Grip end fitting cover centrally between seat belt strap and cover.

Unclip end fitting cover in direction of arrow.

Fig 1: Removing End Fitting Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Install end fitting cover as follows:

Insert cover with rear guide in covering.
Insert cover in direction of arrow downwards in covering
Engage top left of cover in covering.

Fig 2: Installing End Fitting Cover
Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Lever latch mechanism (3) of the cover (2) out of seat mechanism.

Remove cover (2) in direction of arrow from seat mechanism.

Unlock and disconnect plug connections behind from operating unit.

Installation note:

Cover must not be damaged.

Replace cover if necessary.

Fig 3: Removing Cover From Seat Mechanism

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Remove OPERATING UNIT for seat adjustment from cover.