67 62 020 Removing and installing/replacing flat motor for rear left or right power window regulator

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove REAR POWER WINDOW REGULATOR

Release screw connections (1).

Remove flat motor (2) from power window regulator.

Cable must not come loose from power window.

Installation note:

Simultaneously tighten both screw connections (1).

The shaft of the flat motor (2) must be pulled into the holder of the power window regulator under slight tension.

Tightening torque 51 35 1AZ .

Fig 1: Identifying Flat Motor Shaft And Screw Connections

G10097352

Courtesy of BMW OF NORTH AMERICA, INC.

Flat motor (2) must engage exactly at the marked points of the power window regulator (1).

IMPORTANT: Ensure that the flat motor (2) is assembled without tension.

Fig 2: Locating Power Window Regulator And Flat Motor

G10097353

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

An initialization must be carried out in order to activate anti-trap mechanism.

Read and comply with NOTES on initialization of power window regulator.