51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
Detach edge protection (1) in area of side trim panel (2).
Release screw (3).
Remove engine compartment lid release lever (4) from side trim panel (2).
Installation note:
Make sure EDGE PROTECTION (1) is correctly seated.
Release screw (1).
Unclip side trim panel (3) in direction of arrow from retaining points (2).
If necessary, disconnect associated plug connection and remove side trim panel (3).
Installation note:
If necessary, lever out clamps (1) remaining in bore.
Replace faulty clips (1).
Position side trim panel (2) pre-installed with clips (1) on associated bore holes and clip into place.
Replacement:
Modify REAR LID UNLOCKING SWITCH , if applicable.