11 61 350 Removing and installing/renewing pressure pipe at throttle body (N47)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
In the event of a leak at the pressure pipe, there is a risk of damage
to the exhaust turbocharger.
Necessary preliminary tasks:
- Remove ACOUSTIC COVER
- Remove intake silencer housing . See 13 71 000 REMOVING AND INSTALLING/REPLACING INTAKE SILENCER HOUSING (N47) or 13 71 000 REMOVING AND REFITTING/REPLACING INTAKE FILTER HOUSING (N47 WITH SCR) .
NOTE:
Lock (1) must snap into place in bracket (see arrow).
Release lock (1) with a suitable tool.
Disconnect pressure pipe (2) from charge air cooler.
Release lock (1) in direction of arrow.
Release pressure pipe (2) in direction of arrow.
IMPORTANT:
In the event of a leak at the pressure pipe, there is a risk of damage
to the exhaust turbocharger.
Check sealing lip (1) for damage.
Installation note:
If sealing lip (1) is damaged, the gasket must be replaced.
IMPORTANT:
In the event of a leak at the pressure pipe, there is a risk of damage
to the exhaust turbocharger.
Check sealing ring for damage.
Installation note:
If sealing ring is damaged, replace gasket.
Assemble engine.
Check differentiated air intake system for leak tightness.