LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 829 (Restraints - Repair) >> Gas Generators, Airbag Modules (With Steering Wheel Airbag 3234) >> 72 12 060 Removing and installing or replacing left or right head airbag

72 12 060 Removing and installing or replacing left or right head airbag

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Operations on pyrotechnical devices may only be carried out by authorized experts.
Improper, unauthorized operations may result in serious dangers.
Unauthorized persons are strictly prohibited from performing any operations on this system  .
WARNING: Read and comply with SAFETY INSTRUCTIONS  for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
A damaged head airbag must be replaced.
A damaged head airbag exhibits an impaired protective function and in extreme cases loses its protective function altogether.

Necessary preliminary tasks: 

Installation overview, retaining elements, head airbag: 

Fig 1: Overview Of Retaining Elements, Head Airbag
G09929935Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Do not damage during removal!
  • Head airbag
  • Windscreen
  • Retaining clips
  • Trim panels

Release screw (1) on A-pillar.

Tightening torque 72 12 02AZ .

Installation note: 

End fitting is coded against incorrect assembly.

Fig 2: Identifying A-Pillar Screw
G06886671Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 72 12 02AZ .

Fig 3: Identifying Head Air Bag Screw
G09929937Courtesy of BMW OF NORTH AMERICA, INC.
Fig 4: Pressing Retaining Clips
G09929938Courtesy of BMW OF NORTH AMERICA, INC.

Press retaining clips (1) together and remove.

UNLOCK AND DISCONNECT  connector (1) for gas generator.

Unfasten screws (2).

Tightening torque 72 12 02AZ .

Remove gas generator.

Installation note: 

Gas generator is coded against incorrect assembly.

Fig 5: Identifying Gas Generator Connector And Screws
G09928331Courtesy of BMW OF NORTH AMERICA, INC.