65 50 170 Replacing cover for Central Information Display (CID, TPO)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

NOTE: These repair instructions apply to the Central Information Display (CID) of the manufacturer TPO.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary work:

Remove CENTRAL INFORMATION DISPLAY .

Release screws at marked points.

Tightening torque 65 50 3AZ .

NOTE: To tighten screws, use special tool 00 9 460 .

Remove rear cover (1) of central information display (2).

Fig 1: Identifying Rear Cover Of Central Information Display

Courtesy of BMW OF NORTH AMERICA, INC.

Detach adhesive tape fixation (1).

Installation note:

A new adhesive tape is included with the replacement part delivery.

Disconnect plug connection (2).

IMPORTANT: Risk of damage!
The wiring harness (4) can be crushed by the cover (3) at the position marked by the arrow!
Installation note:
The adhesive tape (1) of the wiring harness (4) must be applied before installation of the cover (3)!

Fig 2: Detaching Adhesive Tape Fixation

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws at marked positions.

Tightening torque 65 50 2AZ .

NOTE: To tighten screws, use special tool 00 9 450 .

Feed out cable (2) from guides.

Installation note:

Ensure correct cable routing (2).

Fig 3: Removing Central Information Display Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully raise latch mechanisms (1) and remove central information display cover (3).

Installation note:

Make sure latch mechanisms (1) are heard to click into place.

Make sure cover (3) is correctly seated on central information display.