65 50 125 Removing and installing/replacing left or right rear monitor

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Installation note:

Remove REAR PASSENGER COMPARTMENT MONITOR COVER .

Release screws (1).

Tightening torque 65 50 2AZ .

Remove rear passenger compartment monitor (2) from holder (3).

Installation note:

Make sure rear passenger compartment monitor (2) is correctly seated on holder (3).

Fig 1: Identifying Screws, Rear Passenger Compartment Monitor And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections and disconnect.

Remove monitor in rear (1).

Fig 2: Locating Rear Passenger Compartment Monitor Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/CODING .