37 14 515 Replacing rear left or right ride height sensor
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe SAFETY INFORMATIONS
for raising the vehicle
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST DAMAGE FROM ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Unfasten plug connection (1) and disconnect.
Release nut (2) and disconnect jointed rod.
Tightening torque 37 14 4AZ .
Installation note:
Sensor lever (3) must point from ride height sensor to respective rear wheel.
Replace self-locking nut.
Release screws (1) and remove ride height sensor (3).
Tightening torque 37 14 2AZ
Replacement:
Release screws (1). Remove holder (2) from ride-height sensor.
Tightening torque 37 14 3AZ .
After installation:
- Carry out RIDE HEIGHT ADJUSTMENT
- Check HEADLIGHT SETTING , correct if necessary