52 26 412 Replacing backrest cover for right rear seat (through-loading system)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks:

Remove right BACKREST
Remove GUIDE SLEEVES

Release screw (1).

Tightening torque 52 26 02AZ .

Remove outer mount (2).

Fig 1: Identifying Outer Mount With Mounting Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out welt in the marked area from the backrest frame with special tool 00 9 317 .

Remove backrest cover with padding from backrest frame.

Fig 2: Removing Backrest Cover Welt Using Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and padding:

Release all retainers in marked area
Remove cover from padding
Remove all remnants of retainers from cover and padding

Fig 3: Identifying Retainers In Marked Area
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert new clamp (2) with special tool 52 0 050 and bend closed.

Padding
Retainer
Trim wire in padding
Trim wire in backrest cover
Backrest cover

Fig 4: Inserting Clamp With Special Tool (52 0 050)
Courtesy of BMW OF NORTH AMERICA, INC.

Replacing cover:

Pull all trim wires out of cover
If necessary, cut pockets in new cover for trim wires
Push trim wires into cover pockets

Fig 5: Identifying Trim Wires
Courtesy of BMW OF NORTH AMERICA, INC.