52 26 311 Removing and installing/replacing lock for left or right rear seat backrest (through-loading system)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Unlock and fold back rear seat backrest.

NOTE: If the rear seat backrest cannot be unlocked, carry out EMERGENCY OPENING .

Unclip Bowden cable from holders (1).

Unfasten screws (2).

Tightening torque 52 26 07AZ .

Fig 1: Identifying Bowden Cable From Holders And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Feed lock (1) out of installation opening slightly and unclip Bowden cable (2).

Remove lock completely from installation opening.

Installation:

Catches (2) on lock must not be damaged.

Bowden cable must be correctly anchored in catches (2).

Fig 2: Pulling Rear Seat Backrest Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide guide lug (1) of lock into opening (2).

Fig 3: Sliding Guide Lug Of Lock Into Opening

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Adjustment of lock:

Slacken screws
Firmly push engaged backrest back
Tighten down screws

Tightening torque 52 26 07AZ .