67 61 005 Removing and installing/renewing drive with gearbox (front) for actuating slide/tilt sunroof

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove ROOF SWITCH CLUSTER .

NOTE: Secure drive with gearbox for actuating slide/tilt sunroof (3) against falling out.

Unfasten plug connection (1) and disconnect.

Release screws (2), tightening torque 54 13 1AZ .

NOTE: Screws (2) are microencapsulated.

Remove drive with gearbox for actuating slide/tilt sunroof (3).

Fig 1: Identifying Actuating Slide/Tilt Sunroof, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Insert gear (1) of electric motor with gearbox for operation of slide/tilt sunroof (2) exactly in gearing (3).

Fig 2: Identifying Gear, Actuating Slide/Tilt Sunroof And Gearing

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Initialize SLIDE/TILT SUNROOF .