54 12 115 Removing and installing glass slide/tilt sunroof panel
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove GAITER on left and right.
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused.
- Screw connection must be completed within 20 minutes (start of curing).
- Microencapsulated screws must not be retightened.
- Clean thread of nut beforehand in event of repeated use.
Release left and right screws (1).
Remove glass slide/tilt sunroof panel (2) towards top.
Installation note:
Replace screws (1).
Insert screws (1) but do not tighten down yet.
Adjust glass slide/tilt sunroof panel . See 54 10... NOTES ON GLASS SLIDE/TILT SUNROOF (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) or 54 12 003 ADJUSTING GLASS SLIDE/TILT SUNROOF PANEL .