22 11 001 Replacing right engine mount (N63)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Secure engine in INSTALLATION POSITION .
Remove rear UNDERBODY PROTECTION .
Release ENGINE SUPPORT ARM (left-hand drive models only)
Lower FRONT AXLE SUPPORT (right-hand drive models only)

Release bolt (1) and remove engine mount.

IMPORTANT: Installation note:
To ensure play between engine mount and engine support arm, lower the engine completely before tightening the screw connection (engine mount/engine support arm).
Tightening torque 22 11 2AZ .

Fig 1: Identifying Left Engine Mount (N63) Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Rubber part (1) of engine mount must point to center of vehicle.

Fig 2: Identifying Rubber Section Of Engine Mount

Courtesy of BMW OF NORTH AMERICA, INC.