24 30 100 Replacing Oil Accumulator (GA8HP45Z)
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation.
IMPORTANT:
Applicable to vehicles from 08/2011.
Remove transmission oil sump only after it has cooled down.
After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only the approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Remove transmission oil sump only after it has cooled down.
After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only the approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Installation note:
The transmission oil sump must be renewed every time it is removed.
Necessary preliminary tasks:
- Remove transmission oil sump . See 24 11 014 REMOVING AND INSTALLING/SEALING OR REPLACING TRANSMISSION OIL SUMP (GA8HP45Z) .
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations.
Release screws (1) (M6x20).
Release screw (2) (M6x59).
Tightening torque: 24 30 5AZ .
Carefully unlock connector (3) with screwdriver.
Carefully pull out oil accumulator.
IMPORTANT:
Mounting bolts of oil accumulator must
be replaced after removal.