36 10 715 Checking wheel rim for lateral and radial runout

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove WHEEL
Check WHEEL for lateral and radial runout
Remove TYRE from disc wheel
Remove dirt from rim base and rim flange

IMPORTANT: Disc wheels are not allowed to be repaired!

Mount disc wheel in balancing machine.

Fig 1: Mounting Disc Wheel In Balancing Machine

G04726742

Courtesy of BMW OF NORTH AMERICA, INC.

Use suitable wheel centering element supplied with corresponding balancing machine.

Basic flange
Wheel centering element
Type flange
Clamping nut

Fig 2: Identifying Basic Flange, Wheel Centering Element, Type Flange And Clamping Nut

G08470869

Courtesy of BMW OF NORTH AMERICA, INC.

Place dial gauge sensor on rim shoulder.

Turn wheel by hand and measure max. radial runout. Refer to TECHNICAL DATA - TWO-PART ALLOY WHEELS , TECHNICAL DATA - ONE-PART ALLOY WHEELS , or TECHNICAL DATA - STEEL AND ALUMINIUM STRIP WHEELS .

Carry out measurement on both rim shoulder sides.

NOTE: Dial gauge must be vertical to rim shoulder.

Fig 3: Identifying Dial Gauge Sensor On Rim Shoulder

G04726744

Courtesy of BMW OF NORTH AMERICA, INC.

Position sensor on rim flange.

Turn wheel by hand and measure max. lateral runout. Refer to TECHNICAL DATA - TWO-PART ALLOY WHEELS , TECHNICAL DATA - ONE-PART ALLOY WHEELS , or TECHNICAL DATA - STEEL AND ALUMINIUM STRIP WHEELS .

Carry out measurement on both rim flanges.

NOTE: Dial gauge must be vertical to rim flange.

Fig 4: Positioning Sensor On Rim Flange

G04726745

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Avoid clamping errors during subsequent installation work.