36 11 105 Removing and installing RDC (Tyre Pressure Control) control unit (LOW COST)
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE
(ESD protection).
Necessary preliminary work:
- Remove bottom center COVER .
NOTE:
Image without bumper panel!
Press the bumper panel slightly to the rear.
Disconnect plug connection (1).
Press retaining tabs (2) apart as indicated by arrow.
Pull the RDC control unit out.
Replacement:
- Carry out programming/encoding