12 14 650 Replacing suction pressure sensor on intake plenum (N20)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out the fault memory of the DME control unit.
Switch off ignition.
Partially undo the acoustic cover.

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 5AZ .

Pull out the vacuum pressure sensor (3) from the intake plenum.

Fig 1: Identifying Vacuum Pressure Sensor, Screws And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check sealing ring for damage. Replace damaged sealing ring.

When installing, coat sealing ring with suitable lubricant.

Fig 2: Locating Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Reassemble the vehicle.
Check stored fault message.
Delete fault memory.