12 14 521 Replacing crankshaft pulse sensor (N55 hybrid)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: High-voltage system - danger to life!

The following points must be strictly observed prior to starting work :

Observe SAFETY INFORMATION for handling hybrid cars

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Read out the fault memory of the DME control unit.
Switch off ignition.
Remove STARTER MOTOR .

Unlock connector (1) and remove.

Release screw (2).

Tightening torque 13 62 2AZ .

Remove connector housing from crankcase.

Release screw (3).

Tightening torque 13 62 8AZ .

Pull pulse sensor from crankcase and remove.

Fig 1: Identifying Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

During installation of pulse sensor make sure that guide pin (1) of pulse sensor is inserted in guiding groove (2) of crankcase.

Fig 2: Identifying Guide Pin And Groove

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Assemble engine.
Check stored fault message.
Delete fault memory.