12 14 521 Replacing crankshaft pulse sensor (N52T)
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
IMPORTANT:
Aluminum-magnesium materials.
No steel screws/bolts may be used due to the threat of electrochemical corrosion.
A magnesium crankcase requires aluminum screws/bolts exclusively.
Aluminum screws/bolts must be replaced each time they are released .
Aluminum screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminum screws/bolts are not magnetic .
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
No steel screws/bolts may be used due to the threat of electrochemical corrosion.
A magnesium crankcase requires aluminum screws/bolts exclusively.
Aluminum screws/bolts must be replaced each time they are released .
Aluminum screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminum screws/bolts are not magnetic .
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Necessary preliminary work:
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove rear UNDERBODY PROTECTION .
NOTE:
Installation location of pulse sensor for crankshaft is underneath starter motor.
Detach plug (1) from crankshaft pulse sensor (2).
Release screw.
Installation note:
Replace aluminum screws .
Tightening torque 13 62 2AZ .
Withdraw pulse sensor (2) from crankcase.
Installation note:
Replace sealing ring.
NOTE:
Check stored fault messages.
Delete fault memory.