12 31 020 Removing and installing alternator (N52T)
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Aluminum-magnesium materials
.
No steel screws/bolts may be used due to the threat of electrochemical corrosion.
A magnesium crankcase requires aluminum screws/bolts exclusively.
Aluminum screws/bolts must be replaced each time they are released .
Aluminum screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminum screws/bolts are not magnetic .
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
No steel screws/bolts may be used due to the threat of electrochemical corrosion.
A magnesium crankcase requires aluminum screws/bolts exclusively.
Aluminum screws/bolts must be replaced each time they are released .
Aluminum screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminum screws/bolts are not magnetic .
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Necessary preliminary work:
- Switch off ignition.
- Disconnect BATTERY EARTH LEAD .
- Remove INTAKE SILENCER HOUSING .
- Remove ALTERNATOR DRIVE BELT .
Release connector (1) and remove.
Slacken nut (2).
Installation note:
Tightening torque 12 42 1AZ .
Disconnect positive battery cable from alternator.
Release screws (3) and remove alternator.
Installation note:
Replace aluminum screws .
Tightening torque 12 31 1AZ .
Assemble engine.