64 11 273 Replacing water valve for heater (N52T, N53)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of burning!
Repair work on the cooling system may only be carried out when it has cooled down.

NOTE: Disconnect COOLANT HOSES on water valve.

Recycling

Coolant emerges when coolant lines are detached. Have a suitable collecting vessel ready.

Catch and dispose of escaping coolant.

Observe country-specific waste disposal regulations.

Necessary preliminary tasks:

Remove AIR INTAKE HOSE

NOTE: Picture shows engine removed for purposes of clarity

Release hose clamps (1) and detach coolant hoses.

Disconnect plug connection (2).

Pull water valve (3) upwards out of holders.

Installation note:

Do not mix up connections of coolant hoses.

Replace damaged coolant hoses!

Fig 1: Identifying Hose Clamps, Plug Connection And Water Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure rubber mount (1) and guide lug (2) are securely seated in holders (3) on wheel arch body.

Fig 2: Identifying Holders, Guide Lug And Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Fill and vent cooling system and check for leaks. See ADDING COOLANT and CHECKING FOR WATERTIGHTNESS .