LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Cooling System - Repair) >> Coolant, Checking Cooling System >> 17 00 005 Draining And Adding Coolant (N57 D30 U/O/T 0/1)

17 00 005 Draining And Adding Coolant (N57 D30 U/O/T 0/1)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

WARNING: Risk of scalding!
Only carry out repair work on the cooling system when the engine has cooled down.
IMPORTANT: Lifetime coolant filling: 
Never reuse used coolant!
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be drained and refilled.
In the case of other removal work involving the draining of part quantities of coolant, replace these quantities which have been drained with new coolant.

Installation note: 

Use only recommended coolant .

Observe mixture ratio .

Protective measures/rules of conduct: 

IMPORTANT: For dirt contamination of the cooling system (e.g. by engine oil), the cooling system must be rinsed with water until all dirt contamination is removed!
IMPORTANT: Risk of skidding due to coolant on the floor.
Danger of injury! 

Catch and dispose of drained coolant in drip tray (1) and if necessary special tool 00 2 030 (universal hydraulic lifting equipment).

Recycling: 

Observe country-specific waste disposal regulations.

Fig 1: Supporting Coolant Drip Tray Using Special Tool (00 2 030)
G05476170Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary work: 

Draining coolant: 

Open sealing cap (1) on coolant expansion tank.

Installation note: 

Close the sealing cap (1) until the arrows line up.

Fig 2: Sealing Cap On Coolant Expansion Tank
G06889230Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and detach coolant hose (1) from radiator.

Drain, catch and dispose of coolant.

Fig 3: Coolant Hose From Radiator
G06889231Courtesy of BMW OF NORTH AMERICA, INC.

Adding coolant: 

Use only recommended coolant .

Observe mixture ratio .

Observe CAPACITIES .

Fill and vent COOLING SYSTEM .

Observe bleeding instructions without fail  .

Fig 4: Coolant Level Marks
G06889232Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Visual inspection of cooling system for tightness.

scientia non olet · About LEMON Manuals