61 31 342 Removing and installing/replacing the gear selector switch (GWS)
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .
Necessary preliminary work:
- Remove GEAR SELECTOR SWITCH COVER
Removal:
Release all screws (1).
Take off gear selector switch (2) from center console (3).
Unlock and disconnect corresponding connector.
Installation:
Installation note:
Align gear selector switch (2) centrally.
Connect corresponding connector.
Join gear selector switch (2) to center console (3).
Tighten all screws (1).
Tightening torque 61 31 1AZ .
Replacement:
NOTE:
A new connector with deviating pin assignment will be installed in the following vehicles.
- F25 from 03/2011
- F01, F02, F03, F04, F07 from 09/2011
- F10, F11, F12, F13, F18 from 03/2012
On the above-mentioned vehicles which were produced before the relevant date, the wiring harness must, if necessary, be reconnected from the previous 8-pin connector to a new 10-pin connector (BMW Parts Department 9 132 577) with special tool 61 0 313 .
Pin assignment:
| Eight-pin connector: current pin | Ten-pin connector: new pin |
|---|---|
| 1 | 10 |
| 2 | 7 |
| 3 | 3 |
| 4 | 4 |
| 5 | 8 |
| 6 | 5 |
| 7 | 6 |
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .