61 35 107 Removing and installing or replacing junction box electronics

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .

Necessary preliminary work:

Partially remove POWER DISTRIBUTION BOX FOR PASSENGER COMPARTMENT

Release screws (1) on junction box electronics (2).

Tightening torque 61 14 2AZ .

Fig 1: Identifying Screws On Junction Box Electronics

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Pull junction box electronics (2) out of bracket.

Installation note:

Make sure junction box electronics and plug connections (1) are correctly seated.

Fig 2: Identifying Junction Box Electronics And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/CODING .

Delete transport mode.