51 32 420 Removing and installing/replacing trim on front door window frame, left or right

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

If necessary, open the window glass
Remove front cover on door window frame

Carefully feed out the rubber window seal (1) in working area. When doing this pay attention to the connection to the inner window cavity (see mark).

Installation:

Coat rubber window seal (1) with water before fitting.

Unfasten screws (2).

Fig 1: Identifying Rubber Window Seal And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Graphic is only an example.

Protect top frame trim against scratches.

Move cover (1) somewhat down and feed out above.

Lever out trim (1) to the rear and feed out somewhat to the outside.

Pull out the cover (1) upward over the frame cover.

Installation:

If necessary, replace damaged plastic nuts from the bolts (1).

Fig 2: Pulling Window Frame Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check trim (1) for damage, replace if necessary.

Fig 3: Identifying Window Frame Trim

Courtesy of BMW OF NORTH AMERICA, INC.